Large Markings
Tape marking into position with small pieces of masking tape.
Apply 2" or 3" (5.1 - 7.7cm) tape over top edge to serve as a hinge.
Cut through tape hinge at both edges to facilitate the next step.
Raise marking up over top hinge and peel the liner back a few inches at a time while squeegeeing marking to surface.
Hold marking away from surface with one hand and allow adhesive to touch only as pressure is applied.
Squeegee with firm, overlapping strokes beginning at top center and working down and toward each edge.
Remove premask at 180° (pull back on itself).
Resqueegee entire marking.
